Product Description
Premium Quality. Laboratory Tested. Highly Effective. Safe.
This effective and efficient sterilizer can disinfect a ~225 sq ft room in 15 minutes. With a range of up to ~650 sq ft, this light has intelligent motion sensor safety features that deactivate the light if someone enters the area. Be among the first to get this technology when you preorder now.
UVC technology has been in use by hospitals for its clinically validated effectiveness in killing germs since the 1930s. Any living cell that is exposed to UVC light will be affected—including viru, bacteria, yeast, mold, algae, amoebas, and allergens. The UVC light penetrates outer layers of a cell and damages its DNA or RNA so it cannot reproduce. Soon after, the nucleic acid is destroyed which cau the cell to die. This entire process happens within seconds of adequate UVC exposure.
Simple-structure organisms like viru and bacteria are the most vulnerable to ultraviolet radiation, whether airborne or on a surface.
Features
- Clinically proven to eliminate 99.9% of all viru, bacteria, fungi, mold, yeast, algae, amoebas, and other germs and allergens within seconds of 253.7 nm UVC exposure.
- Can be programmed and set with touch panel or remote control.
- A 360° motion sensor deactivates the lamp when it detects movement within 16 feet.
- Hypoallergenic sanitizing does not leave irritants or toxic chemicals behind.
- Contact-free disinfection reduces the chance of human error and cross-contamination.
- Reduces the need to buy and handle corrosive cleaners. (Does not replace soap/water)
Instructions
Plug in the device and place it in the center of the room about 40” away from the ground. Make sure the area is clear and estimate the size of the room to determine cycle length.
Area Disinfect Time
~225 sq ft = 15 minutes
~450 sq ft = 30 minutes
~550 sq ft = 45 minutes
~650 sq ft = 60 minutes
Manual Operation:
1. Plug in and power on.
2. Press “ON/OFF” button on touch panel.
3. Using the “Time Setting” button select your duration.
4. There is a 10 second delay, then the light activates.
Remote Operation:
1. Plug in and power on.
2. Press “ON/OFF” button on the remote control.
3. Select your duration using a “Time Setting” button.
4. There is a 10 second delay, then the light activates.
Motion Sensor: This activates 20 seconds after the lamp is switched on. When motion is detected within 16 feet the light will turn off, then turn back on after 20 seconds of no motion. To activate or deactivate the sensor, hold down the radar button on the unit until it chimes.
Tips & Safety
- To maximize effectiveness, ensure the room to be disinfected is clear of debris
- Take care to avoid direct or prolonged exposure of UVC to skin and eyes
- Keep out of reach of children and pets, do not leave unattended while not in use
- Clear area of people, plants and animals
- Can be used near food, tests have not shown any loss in quality or nutrition
- Set on a small stand like a tripod
- If the lamp breaks use a wet paper towel to clean up, and do not inhale
- As distance from a subject is increased, exposure time should be prolonged
